Allow 2-3 hours between coats.
APPLICATION
Ensure that the wood is dry, clean and free from dust. The treatment is most effective if wood is bare. Remove surface coatings such as paint, varnish and woodstains. Apply by brush as directed, covering all faces, ends and joints paying particular attention to the end grain, corners, crevices etc. Allow 2-3 hours between coats. Ensure wood is fully dry before any filling, gluing and knotting is carried out and before laying floor tiles, carpet or underlay and loft insulation. For specific guidance on application, refer to application rates on side of pack. Your wood can be finished with a woodstain, varnish or paint once the Woodworm Killer has dried thoroughly. N.B. For treatment of smaller areas of attack, use Ronseal Woodworm Killer Aerosol.
